By investing in the Glastar Bevel Star you have the finest grinding
and polishing station available to the hobby market. Follow these
instructions and you will get the maximum enjoyment and use out of
your new machine.
the Bevel Star, always protect yourself against eye injuries from
flying glass. Protective safety goggles should be worn by persons
beveling and all persons in the immediate area.
Bevel Star System
How to Bevel Guide
1 lb. (.4536kg) Cerium Oxide
Aluminum Screw-Back Discs (4)
120 Grit Genesis Diamond Roughing Pad (1)
400 Grit Genesis Diamond Smoothing Pad (1)
Diamond Resin Pre-Polish pad (1)
Polyester Felt Polish Pad (1)
Water Hook-Up Kit (1)
Genesis diamond grinding pads are available in various grit sizes.
Contact your supplier for details.
grind any metal on the grinding discs. It will make the disc unusable
for grinding glass within a matter of seconds!
A plumbing kit is supplied with your machine. The kit is designed to
connect to a common garden hose connection. Keep in mind that most
laundry and utility sinks have faucet mouths that have matching threads
to a garden hose.
Your machine has a 6' (15.24cm) length of clear plastic tubing for
a drain exit. Place the end of the tube in a large plastic bucket on
the floor. Beveling can be very absorbing work, so much so that you
can find yourself standing in two inches of water by the time you finish
that gorgeous bevel! Pay close attention to the water level, and dump
the bucket when about 3/4 full. Use a reasonable sized drain bucket;
one that will give you lots of beveling time, but something you can
handle without spilling it when it is almost full. Be careful where
you dump the bucket as glass grits and cerium settle very tightly in
drain pipes and over time, can create problems. If you have made the
decision to use a diamond coolant, you will need a recirculating pump
system such as an aquarium or fountain pump.
The grinding and polishing pads are adhesive-backed. To mount the pads
to the discs, peel off the paper backing and apply to flush surface
of the blank discs. When the pads become worn, just peel off and
apply a new one. Be sure that the blank disc is perfectly clean
prior to attaching the new pad. Using a cleaner such as acetone
will insure that all residue is removed before applying new disc.
Discs are easily installed and changed by unplugging your machine,
removing the splash guard and unscrewing the disc. In order to
unscrew the disc, the spindle must be locked by pressing the disc
from the back of the machine. Slowly rotate the spindle until the
pin locks in place, then unscrew the disc counter-clockwise. The
locking device will automatically back out when you release the
You can change the direction of the water/coolant flow by adjusting
the flexible spout. Fot optimum results, we recommend that the coolant
be directed to the center of the disc. The water flow is easily adjusted
by the ball valve in the back of the machine.
Variable Speed Motor
Variable Speed Motor
NO FAULT WARRANTY
WE WILL DO
This warranty is extended by GLASTAR CORPORATION to the original purchaser
and to any succeeding owner. If your GLASTAR GRINDER fails for any
reason within the first 1 year from the date of manufacture, we will
repair the product without charge for parts or labor.
this product, click here
TO OBTAIN SERVICE
If you have any problem with your GLASTAR GRINDER call the GLASTAR
TOLL FREE NUMBER for an authorization number. Then pack the machine
well and return it post-paid to GLASTAR. We will repair your grinder
as rapidly as possible and return it to you post-paid.
IS NOT COVERED
This warranty does not cover wear of the diamond grinding surface.