The Micro Abrasive Blaster is designed to give the user the ability to sandblast with or without a stencil. The precise even flow of abrasive allows you to draw or write directly on the surface of the glass. The unit consists of a machined reservoir, and easily operated foot switch, a nozzle holder the size of a pencil, and the necessary connecting hoses. The Micro Abrasive Blaster comes with a .032 carbide nozzle.
The Micro Abrasive Blaster is designed to operate on compressed air from a compressor or bottled gas. 60 to 120 psi is required and 100 psi plus should be used for carving. Glass beads, aluminum oxide, silicone carbide, and other media's ranging in sizes 150 mesh through 400 mesh can be used. It is recommended that a water separator be used with the Micro Abrasive Blaster. When used in high humidity areas, the abrasive will absorb moisture, causing it to pack. If this happens, you will get an uneven flow of material making it very difficult to work with the unit.
Pencil-Like Hand Piece - delivers a needle-thin abrasive stream at high force making it ideal for precise work. Features a non slip textured body and contoured nozzle
Super Flexible Air Lines - designed to move when and where you move
Sensitive Foot Pedal - delivers immediate on-off response for better control of abrasive stream
Easy To Use Reservoir - conveniently refillable with a screw off top
Quick Change Tips - lets you go from a round tip to a flat tip quickly and easily